If Display Indicates Error Code 52; Adjust Brightness - Yamaha MT09 Owner's Manual

This model is equipped with a self-di-
agnosis device for various electrical
circuits.
If a problem is detected in any of those
circuits, the engine trouble warning
light will come on and the display will
indicate an error code.
If the display indicates any error codes,
note the code number, and then have
a Yamaha dealer check the vehicle.
The self-diagnosis device also detects
problems in the immobilizer system
circuits.
If a problem is detected in the immobi-
lizer system circuits, the immobilizer
system indicator light will flash and the
display will indicate an error code.
TIP
If the display indicates error code 52,
this could be caused by transponder
interference. If this error code appears,
try the following.
1. Use the code re-registering key to
start the engine.
INSTRUMENT AND CONTROL FUNCTIONS
TIP
Make sure there are no other immobi-
lizer keys close to the main switch, and
do not keep more than one immobilizer
key on the same key ring! Immobilizer
system keys may cause signal interfer-
ence, which may prevent the engine
from starting.
2. If the engine starts, turn it off and
try starting the engine with the
standard keys.
3. If one or both of the standard keys
do not start the engine, take the
vehicle, the code re-registering
key and both standard keys to a
Yamaha dealer and have the stan-
dard keys re-registered.
NOTICE
If the display indicates an error co-
de, the vehicle should be checked as
soon as possible in order to avoid
engine damage.
3-12
Brightness control mode
1
1. Brightness level display
This function allows you to adjust the
brightness of the multi-function meter
unit panel to suit the outside lighting
conditions.
To adjust the brightness
1. Turn the key to "OFF".
ECA11591
2. While pushing the "SELECT" but-
ton, turn the key to "ON" and con-
tinue pushing the button until the
display switches to the brightness
control mode.
3. Push the "RESET" button to set
the brightness level.
4. Push the "SELECT" button to re-
turn to the original display.
3