Connecting Audio/Video Components - JVC RX-5000VBK Instructions Manual

Connecting the subwoofer speaker
You can enhance the bass by connecting a subwoofer.
Connect the input jack of a powered subwoofer to the
SUBWOOFER OUT jack on the rear panel, using a cable with RCA
pin plugs.
Powered subwoofer

Connecting Audio/Video Components

You can connect the following audio/video components to this
receiver using cables with RCA pin plugs (not supplied). Refer also
to the manuals supplied with your components.
Use the cables with RCA pin plugs (not supplied).
Connect the white plug to the audio left jack, and the red plug to the
audio right jack.
Audio component connections
CAUTION:
If you connect a sound-enhancing device such as a graphic equalizer
between the source components and this receiver, the sound output
through this receiver may be distorted.
Turntable
Turntable
SUBWOOFER
OUT
Note:
Any turntables incorporating a small-output cartridge such as an MC
(moving-coil type) must be connected to this receiver through a
commercial head amplifier or step-up transformer. Direct connection
may result in insufficient volume.
CD player
Cassette deck or MD recorder
To audio input
To audio input
Note:
You can connect either a cassette deck or an MD recorder to the
TAPE/MD jacks. When connecting an MD recorder to the TAPE/MD
jacks, change the source name, which will be shown on the display
when selected as the source, to "MD." See page 11 for details.
If your audio components have a COMPU LINK-3
terminal
See also page 21 for detailed information about the connection and
the COMPU LINK-3 remote control system.
ANTENNA
FM 75
COAXIAL
AM
PHONO
LOOP
AM
EXT
L
R
To audio output
PHONO
CD player
L
R
To audio output
Cassette deck
PHONO CD TAPE/MD
AUDIO
L
R
OUT IN
(REC) (PLAY)
MD recorder
If an earth cable is
provided for your
turntable, connect the
cable to the ground
terminal ( H ) of the
ANTENNA terminals
on the rear panel.
CD TAPE/MD
AUDIO
OUT IN
(REC) (PLAY)
CD TAPE/MD
AUDIO
OUT IN
(REC) (PLAY)
To audio output
To audio output
5