Advertisement
light becomes a regular motion sensor security light.
OPERATION
1. Turn on the wall switch to activate the light, the light is now under Night mode
2.NOTE: Allow for approximately 1minute calibration time before the sensors resume normal activity.
3.To test, walk through the sensor's detection area.
4.Movement will activated. keep out of detection area and the light will switch off automatically after 3 minutes.
The light will be activated again when detecting any movement.If there is continuing movement in the detection zone, the
light will stay on until movement ceases. (after 3 minutes)
LAMP REPLACEMENT
To isolate the unit, first switch off the unit from the mains power. Allow bulb to cool before attempting to remove it.
Unscrew the lamp cover and take the old lamp out and replace with new one, close the lamp cover and tighten the screws.
WARNING: This fitting will become hot when in use. Allow bulb to cool before touching.
NOTE: THE INTELLIGENT MOTION SENSOR TRACKING LIGHT IS DESIGNED TO ILLUMINATE WHEN THE
DETECTION AREA IS ENTERED BY A PERSON AND WILL DETECT MOVING HEAT SOURCE.
GUARANTEE IMPLIED THAT IT WILL PROVIDE TOTAL SECURITY OR PREVENT ILLEGAL ENTRY.
SPECIFICATION
Detection method:
Passive Infrared Sensor (with continuously detect function)
Sensor range:
10m x 220° (maximum)
Power source:
AC 220-240V 50Hz
Time adjustment:
Fixed at 3 minutes approx.
Load rating:
J-Type 150 Watts Max, or equivalent energy saving lamp
Tested to:
The relevant AS/NZS standards
IP rated:
IP55
Imported and Distributed by:
Hamer Ltd
Ph. 0800 239 239
www.nightwatcher.co.nz
5
THERE IS NO
Advertisement
