Advertisement
FUNCTION
This light is equipped with 3 motion sensors: zone 1 covers 60 degree, zone 2 covers 100 degrees and zone 3 covers 60 degrees.
220 degrees (maximum) in total for 3 zones.
ZONE 1
When Power is first turned on the light will go to self calibration mode for about 1 minute.
During calibration mode the light will switch on for 1 minutes to test bulb activity.
If calibration was done during day time- the light will automatically go to stand by mode until dusk.
If calibration was done during night time-the light will resume normal operation.
The factory default setting is:
Night Mode-the light will turn on for 3 minutes when heat/movements are detected. Steady red LED through the front
lens of the housing indicate system active.
To change detection/light activity to
All Day Mode-push the button at the bottom of the housing .
Push-button programmable functions:
- Night time mode: light works at night only (factory setting)
- All day mode: light works on day and night
Reset function: If the stepper motor of tracking light works abnormal, the hidden LED indicator will flash in red and the
light will stop turning automatically. In All Day mode, the red light will flash for 5 seconds and off for 5 seconds; in
Night mode, the red light will flash in regular pattern. Please simply switch
off and on at the main power supply to reset the tracking light operation.
Below are the possible abnormal situations.
- External force: the light head is blocked by objects or is blown by strong
wind and is unable to turn properly, the hidden LED will flash in red to signal
users the abnormal situation.
- Stepper motor: when stepper motor is out of synchronization ,malfunction
or damaged, the hidden LED will flash in red to signal users the abnormal
situation. Please switch off and on at the main power
supply, If the stepper motor stops working, the tracking
ZONE 2
TOTAL DETECTION RANGE
Hidden LED
4
ZONE 3
Push-button
Left 70°
Right 70°
Advertisement
