Program Timer Operation Procedure; About Timer Operation; Present Time Setting Produre - Mitsubishi Daiya SRK25ZD-S User Manual

PROGRAM TIMER operation procedure

I The timer operations that consist of the combination of the timer being set at both on and off. Once this has been set and operations started,
operations will commence and end at the same time every day as long as the ON/OFF button is not pressed.
HI POWER ECONO
AUTO
PM
HI
MED
LO
ON OFF
ON OFF
FAN SPEED MODE
HI POWER TEMP ECONO
AIR FLOW
TIME CANCEL
ON OFF RESERVE
TIMER
TIME ACL
Changing of set time
Set a new time by using the OFF TIMER or ON TIMER button.

About TIMER operation

Amenity facilities enable to start the operation a little earlier, so that the room approaches optimum tempera-
ture at ON time when the operation is started by ON-TIMER.
• Mechanism
The room temperature is checked 60 minutes before the timer is at ON. Depending on the temperature at that
time, the operation starts 5 to 60 minutes before the timer is at ON.
• The Amenity facility only functions for COOL and HEAT operation mode (including AUTO). It does not
work for DRY mode.
Present time setting procedure
I When inserting the batteries, the present time is automatically set to PM 1:00.
HI POWER ECONO
AUTO
AM
HI
MED
LO
ON OFF
FAN SPEED MODE
HI POWER TEMP ECONO
AIR FLOW
TIME CANCEL
ON OFF RESERVE
TIMER
TIME ACL
Example: When it is desired to stop at 10:30 PM, and then start operation at 8:00 AM,
near the set temperature.
1
Press the ON/OFF button.
I OFF TIMER operation setting
Set by the procedures on page 11.
PM
Set to .
OFF
I ON TIMER operation setting
Set by the above mentioned ON TIMER operation procedures.
AM
Set to
ON
The setting of the lighting of the timer lamp (yellow) of this unit is complete.
The time will be displayed on the remote control unit. The display will change
depending on the operational status.
ON OFF
(Stopped)
Releasing procedure
Press the CANCEL button to turn off the timer indicator.
About Amenity facilities
Example: Set to AM 10:30.
1
Press the TIME switch.
Press with the tip of a ball pen, etc.
The time indicator blanks and can be set to the current time.
2
Press the " or
(Set to AM 10:30)
3
Press the RESERVE button.
The indication changes from blinking to steady lighting and the setting is complete.
NOTE
The timer is set on the basis of the present time, so please set it correctly.
– 12 –
.
ON OFF
(Operating)
In COOL operation
(Stop) Operation starts
Set temperature
Check the room temp.
60 mins. in advance.
" button.
(Operation)
Set time
Press within
15 sec.!