About Your Boiling Water Unit (Bwu); Introduction - Rheem 701 Owner's Manual And Installation Instructions

ABOUT YOUR BOILING WATER UNIT

INTRODUCTION

Thank you for choosing our Rheem Boiling Water Unit. Please take a few minutes to
read this booklet because it contains important information about the correct
installation and operation of your boiling water unit. The Rheem Boiling Water Unit
supplies boiling water. It is made from high quality copper and is designed to be
installed indoors. The Rheem Boiling Water Unit is supplied with all the required
safety controls for installation (not including the isolation valve prior to the boiling
water unit).
WARNING:
This boiling water unit is only intended to be operated by persons who have the
experience or the knowledge and the capabilities to do so. This boiling water
unit is not intended to be operated by persons with reduced physical, sensory or
mental capabilities i.e. the infirm, or by children. Children should be supervised
to ensure they do not interfere with the boiling water unit.
This boiling water unit uses 230-240 V AC electrical power for operation of the
control systems and the electrically operated components. The removal of the
access cover(s) will expose 230-240 V wiring. They must only be removed by a
qualified person.
SAFETY
This boiling water unit is supplied with an over temperature cut-out on the boiling
element to prevent element burn out in the event of control failure. If the electrical
supply cord to the boiling water unit is damaged, it must be replaced by a qualified
competent person in order to avoid becoming a hazard. In Australia phone Rheem
Service on 131 031, in New Zealand phone your nearest Rheem Service Centre on
0800 657 335 for an inspection. For extra electrical protection against power surges
and spikes it is recommended that the user install a surge protector prior to the
boiling water unit.
WARNING:
The Rheem warranty may not cover faults if any of the installed safety devices
are tampered with.
4