Using The Timers; Using The Daily And Recording Timer - JVC MX-J270V Instructions Manual

Using the Timers

There are three timers available — Daily Timer, Recording
Timer, and Sleep Timer.
Before using the timers, you need to set the clock built in the
unit. (See page 9.)

Using the Daily and Recording Timer

You can set the timer whether the unit is turned on or turned
off.
• In the source "TUNER," "CD," or "TAPE," the timer acts
as a Daily Timer. Once the Daily Timer has been set, it will
be activated at the same time every day until the setting is
turned off.
• In the source "TUNER
REC
Timer. After the Recording Timer has been performed, the
details of the setting remain stored but the timer status is set
to off.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
Before you start...
• When using a TUNER or TUNER
play, make sure to select the station.
On the remote control ONLY:
1
Press and hold SHIFT during the
setting procedure.
2
Press TIMER.
The timer indicator lights up on the display.
"TIMER ON" appears for 2 seconds, then the
unit enters on-time setting mode.
," the timer acts as a Recording
as the source to
REC
SHIFT
TIMER
2
3
Press SELECT – or SELECT + to
set the on-time you want the unit
to turn on.
4
Press SET.
"TIMER OFF" appears for 2 seconds, then the
unit enters off-time setting mode.
5
Press SELECT – or SELECT + to
set the off-time you want the unit
to turn off (on standby).
6
Press SET.
The unit enters source selecting mode.
– 25 –
– +
SELECT
4 5
SET
8
– +
SELECT
4 5
SET
8