Dubbing Tapes; Cd Direct Recording - JVC MX-J270V Instructions Manual

On the remote control:
To stop recording temporarily (except when the
playback source is deck A), press REC PAUSE
on the remote control.
The indicator flashes on the display.
To resume recording, press TAPE 2 or TAPE 3 on the
remote control.
The indicator stops flashing and remains lit.
To remove the cassette, press EJECT 0 for deck B.
To record on both sides — Reverse Mode
Press REVERSE MODE so that the Reverse Mode
indicator lights up as —
• When using the Reverse Mode for recording,
start recording in the forward (3) direction first.
Otherwise, recording will stop when recording is done only
on one side (reverse) of the tape.
To cancel Reverse Mode, press the button again so that the
Reverse Mode indicator lights up as —
To record an AM station — Beat Cut
While recording an AM broadcast, beats may be heard
(which are never heard when listening to the broadcast
without recording it.)
If this occurs, press REPEAT repeatedly, while
recording, until the beats are reduced.
• Each time you press the button, the display
changes to show the following:
CUT 2
CUT 1

Dubbing Tapes

When dubbing tapes, make sure that the playback direction of
deck A and deck B are the same.
1
Press TAPE 2 3, then 7.
2
Put the source cassette in deck A, and a
recordable cassette into deck B.
• Put the cassettes in both decks so that the tapes will run
in the forward (3) direction.
3
Press DUBBING.
Dubbing starts.
To stop during dubbing, press 7 on the unit (or
TAPE 7 on the remote control.)
To remove the cassette, press 0 EJECT for deck A and
EJECT 0 for deck B.
REC PAUSE
REVERSE MODE
.
.
REPEAT
CUT 3
DUBBING
To record on both sides — Reverse Mode
Press REVERSE MODE so that the Reverse Mode indicator
lights up as — .
To cancel Reverse Mode, press the button again so that the
Reverse Mode indicator lights up as —

CD Direct Recording

Everything on the CD goes onto the tape in the order it is on
the CD, or according to the order you have made for Program
play.
1
Put a recordable cassette into deck B.
2
Place a disc correctly on the circle of the disc
tray, with its label side up.
3
Press one of the disc number
buttons (CD 1 to CD 3) to select
the disc, then 7.
4
Press CD REC START.
The indicator lights up on the display.
Deck B starts recording and the CD player starts
playing.
When the recording is done, the CD player and deck B
stop.
To stop during CD Direct Recording, press 7 on the unit
(or TAPE 7 on the remote control.)
To remove the cassette, press EJECT 0 for deck B.
To record on both sides — Reverse Mode
Press REVERSE MODE so that the Reverse Mode indicator
lights up as — .
• When using the Reverse Mode for CD Direct Recording,
put a recordable cassette tape into deck B with the font side
facing the holder and start recording in the forward (3)
direction first. When the tape reaches its end while
recording a song in the forward direction (3), the last song
will be recorded at the beginning of the reverse side (2).
If you start recording on the reverse side (2), recording
will stop when recording is done only on one side (reverse)
of the tape.
To cancel Reverse Mode, press the button again so that the
Reverse Mode indicator lights up as —
– 22 –
.
CD
CD
CD
CD REC START
.