Table of Contents
Advertisement
Troubleshooting
If you are having a problem with your unit, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person,
such as your dealer, for service.
Symptom
No sound is heard.
Hard to listen to broadcasts because of
noise.
The disc sound is discontinuous.
The disc tray does not open or close.
The disc does not play.
The cassette holders cannot be opened.
Impossible to record.
Operations are disabled.
Unable to operate the unit from the remote
control unit.
Specifications
Amplifier section – CA-MXJ30
Output Power
100 watts per channel, min. RMS, driven into 6 ohms at 1 kHz
with no more than 10% total harmonic distortion.
Audio input sensitivity/Impedance (at 1 kHz)
AUX:
300 mV/50 kohms
Speakers/Impedance: 6 – 16 ohms
Tuner
FM tuning range: 87.5 – 108.0 MHz
AM tuning range: 530 – 1,710 kHz
CD player
CD Capacity:
3 CDs
Dynamic range:
85 dB
Signal-to-noise ratio: 90 dB
Wow and flutter:
Immeasurable
Cassette deck
Frequency response
Normal (type I):
CrO
(type II):
2
Metal (type IV):
Wow and flutter
0.15% (WRMS)
EN16-22.MX-J30[J]/5
Connections are incorrect or loose.
• Antennas are disconnected.
• The AM loop antenna is too close to the
unit.
• The FM antenna is not properly extended
and positioned.
The disc is scratched or dirty.
• The AC power cord is not plugged in.
• Trays are locked.
The disc is placed upside down.
Power supply from the AC power cord has
been cut off while the tape was running.
Small tabs on the back of the cassette are
removed.
The built-in microprocessor may
malfunction due to external electrical
interference.
• The path between the remote control unit
and the remote sensor on the unit is
blocked.
• The batteries are exhausted.
50 — 14,000 Hz
50 — 14,000 Hz
50 — 14,000 Hz (only for playback)
22
Cause
Check all connections and make
corrections. (See pages 6 to 8.)
• Reconnect the antennas correctly and
securely.
• Change the position and direction of the
AM loop antenna.
• Extend the FM antenna at the best
position.
Clean or replace the disc. (See page 21.)
• Plug the AC power cord.
• Unlock the trays. (See page 14.)
Place the disc with the label side up.
Turn on the unit.
Cover the holes with adhesive tape.
Unplug the AC power cord and then plug it
back in.
• Remove the obstruction.
• Replace the batteries.
Design and specifications are
subject to change without notice.
General
Power requirement:
AC 120 V , 60 Hz
Power consumption:
95 watts / 120 VA (at operation)
16 watts (on standby)
Dimensions (approx.): 265 x 315 x 341 mm (W/H/D)
7
(10
Mass (approx.):
8.3 kg (18.3 lbs)
Supplied accessories
See page 6.
Speaker section — SP-MXJ30
T
ype:
2-way bass-reflex type
Speaker units:
Woofer:
Tweeter:
Power handling capacity: 100 watts
Impedance:
6 ohms
Frequency range:
45 Hz — 22,000 Hz
Sound pressure level: 88 dB/w•m
Dimensions (approx.): 215 x 315 x 230 mm (W/H/D)
1
(8
/
2
Mass (approx.):
3.3 kg (7.3 lbs) each
– 22 –
99.1.27, 6:47 PM
?
Action
7
7
/
x 12
/
x 13
/
in.)
16
16
16
15
15 cm (5
/
") cone x1
16
5.0 cm (2") cone x1
7
1
x 12
/
x 9
/
in.)
16
16
?
?
- Quick Links:
- Connecting Speakers
- Specifications
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
