Common Operations; Setting The Clock; Turning On The Power And Selecting The Sources - JVC MX-J30 Instructions Manual

Common Operations

Setting the Clock

Before operating the unit any further, first set the clock built
in this unit.
1
Press PANEL OPEN/CLOSE.
The unit is turned on and the Powered Rolling
Panel opens automatically.
2
Press TIMER/CLOCK.
A.BASS EX S.MODE
ST
REC
The hour digits start flashing on the display.
Press 4 or ¢ to adjust the
3
hour, then press SET.
A.BASS EX S.MODE
ST
REC
• If you want to correct the hour after pressing
SET, press CANCEL. The hour digits start flashing
again.
Press 4 or ¢ to adjust the
4
minute, then press SET.
A.BASS EX S.MODE
ST
REC
To check the clock time
Press DISPLAY while playing any source.
• Each time you press the button, the source
indication and the clock time alternate on the
display.
To adjust the clock again
If you have adjusted the clock before, you need to press
TIMER/CLOCK repeatedly until the clock setting mode is
selected.
• Each time you press the button, the timer/clock setting
modes change as follows:
DAILY
Canceled
(The hour digits start flashing.)
If there is a power failure
The clock loses the setting and is reset to "AM 12:00." You need to
set the clock again.
EN01-11.MX-J30[J]/5
PANEL
OPEN / CLOSE
TIMER
/CLOCK
PRESET
SET
PRESET
SET
DISPLAY
ON TIME REC
Clock
ON TIME
setting
9
Turning On the Power and Selecting the
Sources
When you press the play button for a particular source (FM/
AM, CD 6, AUX, and TAPE 2 3), the unit turns on, and
the Powered Rolling Panel opens automatically (and the unit
starts playing the source if it is ready — COMPU PLAY
CONTROL).
To listen to the FM/AM broadcasts, press FM/AM. (See
page 11.)
To play back CDs, press CD 6. (See pages 12 – 14.)
To play back tapes, press TAPE 2 3. (See page 15.)
To select the external equipment as the source, press AUX.
FM AM / C D
To turn on the unit without playing, press
POWER so that the STANDBY lamp goes off.
A.BASS EX S.MODE
ST
REC
The Powered Rolling Panel opens automatically.
To turn off the unit (on standby), press POWER
again so that the STANDBY lamp lights up.
The Powered Rolling Panel also closes.
A little power is always consumed even while the
unit is on standby.
To switch off the power supply completely,
unplug the AC power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to "AM 12:00" right away, while the tuner preset
stations (see page 11) will be erased in a few days.
– 9 –
99.1.27, 6:18 PM
TAPE
AUX
STANDBY
POWER
STANDBY
POWER