Makita 2702x1 Instruction Manual page 9

Adjusting depth
of
cut
The depth of cut may be adjusted by turn-
ing the handle. Turn the handle clockwise
to raise the blade or counterclockwise to
lower it.
NOTE:
Use
a
shallow depth setting when cutting
thin materials in order to obtain a cleaner
cut.
Adjusting bevel angle
Loosen the lock lever and turn the hand-
wheel until the desired angle (0"
- 45")
is
obtained. The bevel angle is indicated by
the arrow pointer. After obtaining the
desired angle, tighten the lock lever to
secure the adjustment.
CAUTION:
After adjusting the bevel, be sure to tighten
the lock lever securely.
lever
Handwheel i L , , , , , p o i n t e r
Adjusting positive stops
The tool is equipped with positive stops a t 90" and
45"
to the table surface. To check and
adjust the positive stops, proceed as follows:
Move the handwheel as far as possible by turning it. Place a triangular rule on the table
and check to see if the blade is at 90" or 45" to the table surface. If the blade is at an
angle shown in Fig. A, turn the adjusting screws clockwise; if it is at an angle shown in Fig.
B, turn the adjusting screws counterclockwise to adjust the positive stops.
90" adjusting screw
45" adjusting screw
9