Makita 2702x1 Instruction Manual page 19

ACCESSORIES
CAUTION:
These accessories or attachments are recommended for use with your Makita tool speci-
fied in this manual. The use of any other accessories or attachments might present a risk
of
injury to persons. The accessories or attachments should be used only in the proper and
intended manner.
Dado head set
(Part
NO.
191 5434)
A dado is cutting a rabbet or a wide groove
into the workpiece. The dado head set con-
sists of two outside cutters, three inside
1/8" 118" 1/16"
1 /8"
118"
cutters and paper washers.
Outside cutters : 6" diameter, 118" thick,
Inside cutters : 6" diameter,
118"
thick,
518" arbor hole, 2 pcs.
518" arbor hole,
2
pcs.
inside cutter
Paper washers : 518" arbor hole, 6 pcs.
: 6" diameter, 1/16" thick, 518" arbor hole, 1 pc.
Various combinations of these cutters are used to cut grooves from 1/8" to 112" for use in
making joints, tenoning, grooving, etc.
Dado flange set
(Part
NO.
192693-8)
Dado outer flange
When cutting groove 114". 5/16", 318". 7/16" or 1/2",
use this dado outer flange.
Dado hex nut
When cutting groove 114". 5/16", 318". 7/16" or 1/2",
use this dado hex nut.
Ring
When cutting groove 1/4", 5/16". 3/8", 7/16"
or
112".
use this ring.
Washer
When cutting groove 1/4". 5/16" or
3/8",
use this washer.
19