Makita 2702x1 Instruction Manual page 13

Push stick
A push stick can be easily made from a piece of plywood 19 mm
(3/4") to 25 mm (1
'7
thick.
Make auxiliary fence from 9.5 mm (3/8")
and 19 mm
(3/4")
plywood pieces.
50
mm
(2")
( 1 -1 /2")
40 mm
9.5
mm
140 mm
parallel ( 1
8 , ) (5-1 /2")
Cut out the hatched area on the stick and smooth edges with a file.
(HI
dimension should
be less than 12.7 mm (1/2") so as to be thinner than the workpiece.
Push block
Use a 19 mm (3/4") piece of plywood.
300 mm
(12")
120 mm
(5")
Faceledge
.
50
mm
(2")
Handle should be in center of plywood piece. Fasten with glue and wood screws as
shown. Small piece 9.5 mm x 8 mm x 50 mm
(3
/8" x 5/16" x 2") of wood must always be
glued to plywood to keep the blade from dulling if the operator cuts into push block by
mistake. (Never use nails in push block.)
Auxiliary fence
Fasten w i t h glue a n d w o o d screws.
13