mabe RMM1540Y Use And Care Manual page 83

Water Dispenser (only available with certain models)
Your refrigerator comes equipped with a water dispenser which you
manually fill. You can obtain cold water from the outside of the
refrigerator, saving energy use.
IMPORTANT
* Read the instructions before using.
* The dispenser should only be used with pure drinking water. If it is used with
liquid tany other he manufacturer is not responsible for any damage caused.
* Remember to clean the inside of your refrigerator with a cloth or soft sponge,
and a neutral soap.
How to Start
1.
Clean the system before using it for the first time, and repeat this
process at least once every 30 days never employing the use of
detergents or odorous cleaning products. To do this, turn the
switch to the left take the cylinder and Dairy Shelf on the sides
by both hands and lift. Then, take out the tank pulling it towards
you take out the tank pulling it towards you. Rinse it out with
clean water and throw out the water.
2.
To put the cylinder back into its original position, make sure that
the side tabs match up with those of the door and the lower lip of
the cylinder slides correctly into the valve hole of the dispenser. This
is done by levelling the tabs and pushing down so that the cylinder
fits into the door. Then turn the switch to the right to mantain the
tank in the correct position.
NOTE:
You will see a thin space between the shelf and the door cover,
but this is normal.
Your water tank has a seal that you can take off when you wash
your system. It is important to put it back in a correct way.
Seal tabs must be inside of the inner tank wall as shown in the
image so that it avoids spills.
2
83
4
1
3