Listening To Fm And Am Broadcasts; Setting The Tuner Interval Spacing; Tuning In To A Station; Presetting Stations - JVC LVT1364-006B Instructions Manual

Listening to FM and AM Broadcasts

Setting the Tuner Interval Spacing

You can only change the FM or AM tuner interval spacing
while tuning in to a FM or AM station.
On the unit ONLY:
1
Press FM/AM to select either "FM"
or "AM."
2
Turn the VOLUME + / –
control while pressing and
holding 7.
As you turn the VOLUME + / –
control, the interval spacing for the
selected band alternates as follows:
• For FM: 50 kHz* and 100 kHz
• For AM: 9 kHz* and 10 kHz
* Initial setting
When you change the setting
The preset stations for both FM and AM are erased. You will need to
preset the stations again. (See the right column.)

Tuning in to a Station

1
Press FM/AM to select either "FM"
or "AM."
The unit automatically turns on and tunes in to
the previously received station—either FM or AM.
• Each time you press the button, the band alternates
between FM and AM.
• If the station previously selected is stored in a preset
number, the preset number will appear instead of "FM"
or "AM."
2
Press and hold ¢ or 4 (or
UP ¢ or DOWN 4 on the
unit) for more than 1 second.
• ¢ (UP ¢):
Increases the frequencies.
• 4 (DOWN 4): Decreases the frequencies.
The unit starts searching for stations and stops when a
station of sufficient signal strength is tuned in.
• If an FM program is broadcast in stereo, the ST (stereo)
indicator lights up on the display (only when the
reception is good).
To stop during searching, press ¢ or 4 (or UP ¢ or
DOWN 4 on the unit).
The frequency changes step by step.
FM/AM
To change the FM reception mode
On the remote control ONLY:
DOWN UP
4 7 ¢
When an FM stereo broadcast is hard to
receive or noisy, press FM MODE so that the
"MONO" appears on the display. The MONO
indicator also lights up. Reception will improve.
+
To restore the stereo effect, press FM MODE again so that
"STEREO" appears on the display and the MONO indicator
VOLUME
goes off. In stereo mode, you can hear stereo sound when a
stereo program is broadcast.
The stereo effect also restores when:
• Changing the band (FM or AM).
• Changing the station frequency.
• Changing the playing source.
• Turning off (or on) the unit.
To reduce the beat—Beat Cut
On the remote control ONLY:
If the beats are heard, press BEAT CUT
repeatedly until the beats are reduced.
• Each time you press the button, the display
alternates between "CUT-1" and "CUT-2."
FM/AM

Presetting Stations

You can preset 30 FM and 10 AM stations manually.
In some cases, test frequencies have been already stored
for the tuner since the factory examined the tuner preset
MHz
function before shipment. This is not a malfunction. You
can preset the stations you want into memory by following
the presetting method.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start again from step 2 .
UP
PRESET
GROUP
On the remote control ONLY:
DOWN
PRESET
GROUP
1
2
When you repeatedly press ¢ or 4 (or UP ¢ or
DOWN 4 on the unit)
Tune in to the station you want to preset.
• See "Tuning in to a Station" on the left column.
Press SET.
"00" starts flashing on the display.
PRGM
Continued
FM MODE
BEAT CUT
SET
MHz
16