Opening And Closing; Resetting - Mercedes-Benz C-Class Coupe Operator's Manual

Opening and closing

Overhead control panel
To open
:
To open
;
To close
=
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Press or pull the 3 switch in the
X
corresponding direction.
i
If you press the 3 switch beyond the
point of resistance, an automatic opening/
closing process is started in the
corresponding direction. You can stop
automatic operation by operating the
switch again.
Resetting the sliding sunroof and the
roller sunblind
Reset the sliding sunroof and the roller
sunblind if the sliding sunroof or the roller
sunblind does not move smoothly.
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Pull the 3 switch repeatedly to the point
X
of resistance in the direction of arrow =
until the sliding sunroof is fully closed.
Keep the 3 switch pulled for an
X
additional second.
Pull the 3 switch repeatedly to the point
X
of resistance in the direction of arrow =
until the roller sunblind is fully closed.
Keep the 3 switch pulled for an
X
additional second.
Make sure that the sliding sunroof
X
( page 88) and the roller sunblind
Y
( page 89) can be fully opened again.
Y
If this is not the case, repeat the steps
X
above again.
! If the sliding sunroof and the roller
sunblind cannot be fully closed or reset,
contact a qualified specialist workshop.
Problems with the sliding sunroof
Problem: the sunroof cannot be closed
and you cannot see the cause.
G
WARNING
If you close the sliding sunroof again
immediately after it has been blocked or
reset, the sliding sunroof closes with
increased or maximum force. The reversing
feature is then not active. Parts of the body
could be trapped in the closing area in the
process. This poses an increased risk of injury
or even fatal injury.
Make sure that no parts of the body are in the
closing area.
If somebody becomes trapped:
release the switch immediately, or
R
during automatic operation, push the
R
switch briefly in any direction
The closing process is stopped.
If the sliding sunroof is obstructed during
closing and reopens again slightly:
Immediately after the sliding sunroof
X
blocks, pull the 3 switch in the
overhead control panel down to the point
of resistance and hold it until the sliding
sunroof is closed.
The sliding sunroof is closed with increased
force.
If the sliding sunroof is obstructed again
during closing and then reopens slightly:
Immediately after the sliding sunroof
X
blocks, pull the 3 switch in the
I n f o r m a t i o n P r o v i d e d b y :
Sliding sunroof
Z
89