Care; Notes - Mercedes-Benz C-Class Coupe Operator's Manual

Hide thumbs Also See for C-Class Coupe:
Table of Contents

Advertisement

Slowly turn cap : half a turn counter-
X
clockwise and allow excess pressure to
escape.
Turn cap : further counter-clockwise and
X
remove it.
If the coolant is at the level of marker bar
= in the filler neck when cold, there is
enough coolant in coolant expansion
tank ;.
If the coolant level is approximately 0.6 in
(1.5 cm) above marker bar = in the fuel
filler neck when warm, there is enough
coolant in expansion tank ;.
If necessary, add coolant that has been
X
tested and approved by Mercedes-Benz.
Replace cap : and turn it clockwise as far
X
as it will go.
For further information on coolant, see
(
page 337).
Y
Adding washer fluid to the windshield
washer system/headlamp cleaning
system
G
WARNING
Certain components in the engine
compartment, such as the engine, radiator
and parts of the exhaust system, can become
very hot. Working in the engine compartment
poses a risk of injury.
Where possible, let the engine cool down and
touch only the components described in the
following.
G
WARNING
Windshield washer concentrate is highly
flammable. If it comes into contact with hot
engine components or the exhaust system it
could ignite. There is a risk of fire and injury.
Make sure that no windshield washer
concentrate is spilled next to the filler neck.
To open: pull cap : upwards by the tab.
X
Add the premixed washer fluid.
X
To close: press cap : onto the filler neck
X
until it engages.
The washer fluid reservoir is used for both the
windshield washer system and the headlamp
cleaning system.
If the washer fluid level drops below the
recommended minimum of 1 liter, a message
appears in the multifunction display
prompting you to add washer fluid
(
page 230).
Y
Further information on windshield washer
fluid/antifreeze (

Care

General notes
! For cleaning your vehicle, do not use any
of the following:
dry, rough or hard cloths
R
abrasive cleaning agents
R
solvents
R
cleaning agents containing solvents
R
Do not scrub.
Do not touch the surfaces or protective
films with hard objects, e.g. a ring or ice
scraper. You could otherwise scratch or
damage the surfaces and protective film.
I n f o r m a t i o n P r o v i d e d b y :
Care
page 338).
Y
273
Z

Advertisement

Table of Contents
loading

Table of Contents