Sony KDL-32W5800 Service Manual page 7

System
Panel system LCD (Liquid Crystal Display) Panel
TV system Analogue: Depending on your country/area selection: B/G/H, D/K, L, I
Digital: DVB-T/DVB-C
Satellite: DVB-S/DVB-S2
Colour/video system Analogue: PAL, PAL60 (only video input), SECAM, NTSC3.58, NTSC4.43 (only video input)
Digital: MPEG-2 MP@ML/HL, H.264/MPEG-4 AVC MP/HP@L4
Channel coverage Analogue: VHF: E2–E12/UHF: E21–E69/CATV: S1–S20/HYPER: S21–S41
D/K: R1–R12, R21–R69/L: F2–F10, B–Q, F21–F69/I: UHF B21–B69
Digital: VHF/UHF
Satellite: IF Frequency 950-2150 MHz
Sound output 10 W + 10 W
Input/Output jacks
Aerial/Antenna cable 75 ohm external terminal for VHF/UHF
Satellite antenna Female F-Type Connector IEC169-24, 75 ohm.
DiSEqC 1.0, LNB 13V/18V & 22KHz tone
/ AV1 21-pin scart connector (CENELEC standard) including audio/video input, RGB input and TV audio/video
output.
/ / AV2 21-pin scart connector (CENELEC standard) including audio/video input, RGB input and selectable audio/
video output.
COMPONENT IN Supported formats: 1080p, 1080i, 720p, 576p, 576i, 480p, 480i
Y: 1 Vp-p, 75 ohms, 0.3V negative sync/P
P /C
R R
COMPONENT IN Audio input (phono jacks)
HDMI IN1, 2, 3, 4 Video: 1080/24p, 1080p, 1080i, 720p, 576p, 576i, 480p, 480i
Audio: Two channel linear PCM: 32, 44.1 and 48 kHz, 16, 20 and 24 bits, Dolby Digital
Analogue audio input (minijack) (HDMI IN1 only)
PC Input (See below)
AV3 Video input (phono jack)
AV3 Audio input (phono jacks)
DIGITAL AUDIO Digital optical jack (Two channel linear PCM, Dolby Digital)
OUT (OPTICAL)
Audio output (phono jacks)
PC IN PC Input (D-sub 15-pin) (See below)
G: 0.7 Vp-p, 75 ohms, non Sync on Green/B: 0.7 Vp-p, 75 ohms/
R: 0.7 Vp-p, 75 ohms/HD: 1-5 Vp-p/VD: 1-5 Vp-p
PC audio input (minijack)
USB port
i
Headphones jack
CAM (Conditional Access Module) slot
LAN 10BASE-T/100BASE-TX connector (Depending on the operating environment of the network, connection
speed may differ. 10BASE-T/100BASE-TX communication rate and communication quality are not
guaranteed for this TV.)
PC input signal reference chart for
Resolution
Signals Horizontal
(Pixel)
640
VGA
640
720
800
SVGA
800
1024
XGA
1024
1024
1280
WXGA
1280
1280
1280
1360
1280
SXGA
1920
HDTV
1920
* 1080p timing when applied to the HDMI input will be treated as a video timing and not a PC timing. This
affects the "Video Settings" menu and "Screen" menu settings.
To view PC contents, set "Screen Format" to "Wide" and "Display Area" to "Full Pixel".
~
• This TV's PC input does not support Sync on Green or Composite Sync.
• This TV's PC input does not support interlaced signals.
• For the best picture quality, it is recommended to use the signals in the above chart with a 60 Hz vertical
frequency (boldfaced).
/C
B B
: 0.7 Vp-p, 75 ohms
PC and HDMI IN 1, 2, 3, 4
Horizontal
× Vertical
frequency (kHz)
(Line)
× 480 31.5
× 480 37.5
× 400 31.5
× 600 37.9
× 600 46.9
× 768 48.4
× 768 56.5
× 768 60.0
× 720 45.0
× 768 47.4
× 768 47.8
× 960 60.0
× 768 47.7
× 1024 64.0
× 1080 66.6
× 1080 67.5
-  -
: 0.7 Vp-p, 75 ohms/
Vertical Standard
frequency (Hz)
60
75
70
60
75
60
70
75
60
60
60
60
60
60
60
60
VESA
VESA
VESA
VESA
VESA
VESA
VESA
VESA
EIA
VESA
VESA
VESA
VESA
VESA
VESA*
EIA*