Common Operations; Turning On Or Off The Power; Saving The Power Consumption While On Standby -Ecology Mode; Setting The Clock - JVC HX-Z3 Instructions Manual

Common Operations

Turning On or Off the Power

To turn on the unit, press
STANDBY/ON on the remote control)
so that the lamp on the button goes off.
To turn off the unit (on standby), press
(or STANDBY/ON on the remote control)
again so that the lamp on the button lights up.
• A little power is always consumed even while
the unit is on standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to "AM 12:00" right away, while the tuner preset
stations (see page 12) will be erased in a few days.
Saving the Power Consumption while on Standby
—Ecology Mode
You can save the power consumption while the unit is turned
off (on standby).
• You can set Ecology Mode whether the unit is on or off.
On the unit ONLY:
To activate the Ecology Mode, press ECO.
"ECO" appears on the display for 2 seconds (and
the demonstration is canceled temporarily if you
have pressed the button while the unit is off).
• Each time you press the button, "ECO" and "NORMAL"
appear alternately on the display.
To deactivate the Ecology Mode, press ECO again.
"NORMAL" appears (and the demonstration starts if the unit
is turned off).
When you turn off the unit with Ecology Mode activated
"ECO" flashes on the display, and the clock time will not be shown
while the unit is turned off.
(or
ECO

Setting the Clock

You can set the clock whether the unit is on or off; however,
if Ecology Mode is activated, you cannot set the clock while
the unit is off (on standby).
If Ecology Mode is not in use while the unit is turned off (on
standby), "AM 12:00" flashes on the display until you set the
clock.
On the unit ONLY:
1
Press CLOCK/TIMER.
The hour digits start flashing on the display.
2
Turn 4 / ¢ to adjust the
hour, then press SET/DISPLAY.
The minute digits start flashing on the
display.
If you want to correct the hour
after pressing SET/DISPLAY,
press CANCEL/DEMO.
The hour digits start flashing again.
3
Turn 4 / ¢ to adjust the minute, then
press SET/DISPLAY.
To check the clock time while playing a source
Press and hold SET/DISPLAY.
• Each time you press and hold the button, the source
indication and the clock time alternate on the display.
To adjust the clock again
If you have set the clock before, press CLOCK/TIMER
repeatedly until the clock setting mode is selected.
• Each time you press the button, the clock/timer setting
modes change as follows:
DAILY
Canceled
(The hour digits start flashing.)
When you unplug the AC power cord or if a power
failure occurs
The clock loses the setting and is reset to "AM 12:00." If this
happens, set the clock again.
– 9 –
CANCEL / DEMO
TIMER REC
(Daily Timer setting)
Clock
TIMER
setting
(Recording Timer setting)
CLOCK
/ TIMER
SET /
DISPLAY