Connecting To The Antenna - Topfield SRP-2110 User Manual

16 Setup

2.4.1 Connecting to the antenna

Normally you do that by using a loop cable to link from the
LNB 1 OUT connector to the LNB 2 IN connector.
have two antennas without DiSEqC switch, then you have to
connect the cable from the other antenna directly to the LNB 2
IN connector rather than using the loop cable.
NOTE
The digital receiver can supply a current of 500 milliampere
at maximum for antenna devices including LNB, DiSEqc
switch and antenna rotor through each antenna input con-
nection separately but not simultaneously. If there are too
many antenna devices to be simultaneously supplied with
sufficient power for a rather long time through the antenna
input connections, then your antenna may lack power to op-
erate. So it is recommended to link the LNB 1 OUT connector
to the LNB 2 IN connector with a loop cable, even though the
digital receiver is designed to operate independently over
two antennas.
NOTE
Perhaps you are expecting that the satellite antenna could
simultaneously catch all frequencies coming from a satellite
Whatever sort of connection you have be-
tween the digital receiver and the television,
you need to connect the digital receiver to the
antenna so that it can receive digital televi-
sion broadcasts.
ble to the LNB 1 IN connector on the back
panel of the digital receiver.
must ensure that there is a connection to
both the LNB 1 IN and LNB 2 IN connectors
on your digital receiver, so that both tuners
work properly.
Connect the antenna ca-
Also, you
If you