Starting And Stopping - GreenWorks 1500 PSI Operator's Manual

OPERATION
STARTING AND STOPPING THE PRESSURE WASHER
C A U T I O N :
Do not run the pump without the water supply connected and turned on.
• Connect the garden hose.
• Turn the garden hose on then squeeze the high pressure trigger to relieve air pressure. Once a
steady stream of water appears, release the trigger.
• After ensuring the On/Off switch is in the OFF ( O ) position,connect the pressure washer to the
power supply.
NOTE: For ease of use during operation, you may thread the electrical cord through the coils of the garden
hose before connecting to power supply
• Press the reset button on the pressure washer's plug to make sure the unit is ready for
operation.
• Press ON ( I ) on the switch to start the motor.
• To stop the motor, release the trigger and press OFF ( O ) on the switch.
W A R N I N G
Hold the handle and wand securely with both hands. Expect the trigger handle to move when the
trigger is pulled due to reaction forces. Failure to do so could cause loss of control and injury to
yourself and others.
.
On/Off switch
(See Figure 11.)
Fig. 11
18