Hoover washing machine Instruction Book page 34

Water on the floor around the washing machine...
Is the fill hose tightened? If so, replace the rubber washers and re-tighten.
●
Is the standpipe or the household drain blocked? If so, clear the blockage yourself
●
or call a plumber.
Is there clothing or dirt between the door gasket and the door glass? Ensure that
●
the door glass and gasket are kept clean and free of laundry when loading the
machine.
The machine does not spin...
Water has not drained from the machine? Check the points highlighted above.
●
Have you selected an option that changes the spin profile (change of spin speed)?
●
Check the feature in the description of the controls.
Is the load unbalanced? To reduce noise and vibration and improve the machine's
●
reliability and life, the machine is fitted with an electronic sensor that detects if the
load is unbalanced. To improve the spin performance the load can be re-distributed
by hand at the end of the cycle and then re-spun.
The presence of excessive foam has aborted the spinning phase.
●
Do not use excessive amounts of detergent.
The machine is noisy or vibrates a lot during the cycle...
Has the transit system been fully removed? (see Unpacking the Product).
●
Are there any loose items in the pockets of clothing that can rattle in the drum
●
and cause damage?
Is the load unbalanced? Stop the programme, redistribute the load and restart.
●
The programme takes a long time...
Some programmes do take a long time (over 2.5 hours). Low water pressure can
●
increase the length of the programme.
34