Tension Adjustment; Troubleshooting - usi PROMOUNT PLUS 2700 Owner's Manual

TENSION ADJUSTMENT

Top and bottom supply rolls should have about the same tension. By turning the top roll with one
hand, and the bottom roll with the other hand, it can be determined if one of the rolls is tighter
than the other.
To increase tension, turn the adjusting knob clockwise. To decrease tension, turn the knob
counter clockwise. If the tension is not equal top an bottom, the laminated product will curl. If it
curls up when it comes out of the machine, the top roll is probably tighter than the bottom. If it
curls down, the bottom roll is probably tighter. Even tension on the top and bottom ensures flat
lamination.
REVERSE
The machine has a "REVERSE" function. By pressing the "REVERSE" key, the user can pull
out the documents from the machine to prevent any jam or damage.
CUT-OFF KNIFE
Use the knife set (in the backside of the machine) to trim the documents.
TURN OFF LAMINATOR
When finishing the laminating job, please press the "COOL" key to turn off the heat. The motor
will stop only when the roll temperature is lower than 80°C (176°F) to protect the heated rolls.
We recommend to keep the motor running and turn off the machine only after the roll
temperature is lower than 50°C (122°F). However, incase you need to turn off the motor while
roll temperature is higher than 80°C (176°F), you can adjust the speed to "1" and press the
motor speed key for 3 seconds. If so, the speed will jump to "0" and the motor will stop.
1. This laminator is made to use a 1" core with maximum width 690mm (27") roll film.
2. If user wants to hold the lamination just temporary without turning off the machine, this can
be done by pushing the HANDLE forward to release hot & pull rolls. This will cause the film
to stop running. Pull the HANDLE backward again to engage the hot/pull rolls and the
machine can do the lamination job again.
3. You can stop lamination by controlling the handle.
TROUBLE SHOOTING
1. The screen will appear "ER1" if the thermometer inside the machine is damaged. In this
case, the machine will turn off automatically in order to protect the machine.
2. The screen will appear "ER2" if the machine keeps heating over 12 minutes. In this case, the
machine will turn off automatically in order to protect the machine.
3. The screen will appear "ER3" if the machine temperature is higher than 200°C (392°F). In
this case, the user will hear "BUZZER" and the machine will turn off automatically in order
to protect the machine.
4. Any of these error messages: ER1/ER2/ER3 may indicate possible replacement needed of PC
board. Please contact your vendor or dealer.