usi PROMOUNT PLUS 2700 Owner's Manual page 4

HEAT & SPEED ADJUSTMENT
1. Turn on the power switch, the digital screen display will show the previous temperature
setting. Please set the temperature to 90°C (194°F) to start the heat process. By pressing the
" " or " " key of the "TEMP/SET", users can re-set the temperature. The lowest
temperature this machine can be set is 90°C (194°F). The digital screen display will beep
showing the set temperature for 3 seconds. After that, it will show the actual machine
temperature.
2. Press the "HOT" key for heating once the temperature is set and the heater light will glow.
3. The machine will buzz/beep once it reaches 80°C (176°F) for at least 3 minutes. This is to
alert the user that the machine will start running. You can stop the beep by setting the motor
speed to 1.
4. Press the " " or "
below gives some common temperature/speed settings for typical uses.
Notes:
If the machine is left unattended and the motor speed is not adjusted, the machine will stop in
approximately 3 minutes. This feature protects the Hot Rollers as they must constantly turn
while the heat is on.
FILM THICKNESS
1.5 Mil (38 Micron)
3 Mil (75 Micron)
5 Mil (125 Micron)
10 Mil (250 Micron)
" key of "MOTOR" to set the motor speed for lamination. The table °C
Temperature
110°C / 230°F
110°C / 230°F
125°C / 257°F
135°C / 275°F
ProMount Plus 2700
Speed
4
3
3
3