Important Safeguards; How To Use - usi PROMOUNT PLUS 2700 Owner's Manual

OPERATING INSTRUCTIONS

IMPORTANT SAFEGUARDS

1
When using electrical appliances, basic precautions should always be followed to reduce the risk
of electric shock and injury to people, including the following:
1. Read all instructions.
2. Always unplug the appliance when not in use or before cleaning.
3. Do not use outdoors.
4. Extreme caution should be taken when the appliance is used by or near children or invalids.
5. To protect against risk of electrical hazards, do not immerse cord, plugs, or appliances in water
or other liquids.
6. Do not operate the appliance with a damaged cord or plug, or after the appliance
malfunctions, has been dropped or is damaged in any manner. Return appliance to the nearest
authorized service facility for examination, repair, or adjustment.
7. Do not use accessory attachments not recommended or sold by the appliance manufacturer.
8. Do not let cord hang over edge of counter, or touch hot surfaces.
9. Do not use the appliance for other than intended use. This appliance is intended for Office
or Household use only.
10. The Socket outlet shall be installed near the equipment and shall be easily accessible.
11. Warning: Hazardous moving parts - keep fingers and other body parts away.
LOCATION
2
Please remove the laminator carefully from the transit packaging, place the machine on a flat
work surface. Locate the machine in the area where it will normally be used ensuring adequate
room for the finished laminate to feed out at the back.

HOW TO USE

3
LOADING THE FILM.
Unpack the upper and lower rods. Remove feed tray. Slide the roll of film onto the rods, leaving
equal lengths of rod out of each end. Use the guide marks to position the roll of film. Load the
rods onto the laminator.
THREAD THE FILM.
Do not mistake the re-inforcing bar for idler roller. To thread the film through the "hot" rolls
& pull rolls, please pull the handle forward to release pressure on all the rollers. Push the film
through the rollers and make sure the film is perfectly aligned top and bottom.
(Note: overlap will cause the film to deposit residue on the hot roll and pull rolls, so this
procedure is critical). Replace the feed tray.
ProMount Plus 2700