Startincjstopping Instructions - Ryobi Lawn Hornet RLH1100A MKIII Operator's Manual

STARTING/STOPPING INSTRUCTIONS
1. MIX OIL WlTH FUEL AND FILL FUEL TANK
WlTH FUEUOIL MlXTLlRE
-
per instructions on
page
6.
2.
Put the IGNITION SWITCH IN THE "ON"
POSITION. See Fig. 8 for the location of the
ONIOFF SWITCH.
3. FULLY PRESS AND RELEASE THE PRIMER
BLlLB 5 TO 7 TIMES. See Fig. 9 for the primer
bulb location.
4.
PLACE THE CHOKE LEVER IN THE FULL
"CHOKE" POSITION (Fig. 10).
5. WlTH THE UNIT ON THE GROUND, SQUEEZE
THE T H R O T L E TRIGGER FULLY AND PULL
THE STARTER ROPE BRISKLY (Fig. 11) until
the engine sounds like it wants to run. (Normally
2 to 5 pulls).
6.
PLACE THE CHOKE LEVER IN THE
"PARTIAL" CHOKE POSITION (Fig. 10). PULL
THE STARTER ROPE BRISKLY 1 TO 3 TIMES
TO START M E ENGINE (Fig. 11).
7.
If the engine does not start, repeat steps
4
through 6.
8. After the engine warms up for 5 to 10 seconds,
PLACE THE CHOKE LEVER IN THE "RUN"
POSITION (Fig. 10).
9. To stop the engine, put the IGNITION SWITCH
IN THE "OFF" POSI-TION (Fig.
8).
Fig.
8
Fig.
9
Choke Choke Lever
Run
Position Position
Partial
-
-
Choke
-
Position-
1
Fig. 10
Throttle
Trigger
Fig. 11