Split Boome Assembly - Ryobi Lawn Hornet RLH1100A MKIII Operator's Manual

-
ASSEMBLY INSTRUCTIONS (Continued)
OPERATING THE SPLIT B O O W
COUPLER
Model RLH1100A is equipped with a Split Boom' coupler,
which enables optional attachments to be installed on this
unit.
The optional attachments are:
Sweeperh3lower
...............................................
RLSl 1 O O A
Vacuum
..............................................................
RLVl1 O O A
Edger
..................................................................
RLEl1 O O A
Cuttivator
.......................................................
RGCl1 O O A
Removing the Lower (Attachment) Boom
m
NOTE: To make removing the boom easier,
place the unit on the ground or on a table.
1. Loosen the wing screws (Fig. 7).
2 . Push the release button (Fig. 5).
3. Pull the lower boom straight out of the coupler (Fig. 6).
NOTE: The release button must be lined up with
the sight hole when pulling the boom out
of the coupler. If it is not, you will damage
the coupler and the boom.
Upper B o o m Release
+ Q
Button
Fig.
6
Fig. 7
Wing
Screw
Back Side of Coupler
Fig.
5
Installing the Lower (Attachment) Boom
1. Loosen the wing screws. This will allow the lower
boom to be inserted into the coupler (Fig. 6).
2. Remove the protective cover or hanger from the lower
(attachment) boom. Push the lower (attachment) boom
into the coupler (Fig. 7).
3. Locate and lock the release bunon into the hole in
coupler (Fig. 5).
4. Check the sight hole to make sure both ends of the
boom are together (Fig. 7). Tighten the wing screws
before using the unit.