Advertisement
5.6
CHANGING DRIVE BELT
5.6.1
Remove the circular sanding disc to gain access to the allen bolt that secures the aluminium sanding plate.
5.6.2
Remove the allen bolt and washer (fig 4), followed by the bolt cup (fig 5), you can then see the Woodruff Key (fig 6). When reffiting the
disc plate you must align the groove in the disc with the Woodruff Key.
fig.4
5.6.3
When the disc has been removed, undo the lower cover screw (fig 7) and the upper cover screw (fig 8), remove the disc belt cover.
5.6.4
Remove the old belt.
5.6.5
Fit the new belt over the lower motor spindle pulley and over the top pulley as in fig 9. To help engage the belt pulley with the top
pulley teeth, rotate the motor spindle anti-clockwise while applying horizontal pressure to the belt at the top pulley (fig 9). Ensure the
belt is correctly located on both pulleys. Fig 10 shows the belt in the correct location on the upper pulley.
fig.7
5.6.6
The correct belt tension is shown in fig 11, with a firm pressure you should be able to squeeze the belt 5mm on each side. Do not
over tighten as this will damage the motor bearings and belt. The belt should not be slack as it may run off the pulleys during use.
5.6.7
The belt tensioners are shown in (fig 12 "horizontal adjusters" & 13 "vertical adjuster").
5.6.8
When squeezing the belt; if the motor pulley rises, adjust the vertical adjuster (fig 13) until there is no more vertical play in the motor.
Note: When you are satisfied the belt tension is correct, turn the belt through a couple of revolutions to ensure belt, pulleys etc. all turn freely.
5.6.9
Re-assembly is a reversal of procedures 5.6.1 to 5.6.3.
fig.11
WARNING: The warnings, cautions and instructions discussed in this manual cannot cover all possible conditions and situations
that may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must
be applied by the operator.
6. DECLARATION OF CONFORMITY
BENCH TOP BELT/DISC SANDER
Model SM14.V5
2006/95/EC Low Voltage Directive
2004/108/EC EMC Directive
2006/42/EC Machinery Directive
93/68/EEC CE Marking Directive
2002/95/EC RoHS Directive
2002/96/EC WEEE Directive
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our catalogue and latest promotions call us on 01284 757525 and leave your full name, address and postcode.
fig.5
fig.8
fig.12
Declaration of Conformity
in conformity with the following standards and directives.
Signed by Steve Buckle
The construction file for this product is held by the Manufacturer and may be inspected, by a national authority,
upon request to Jack Sealey Ltd. For Jack Sealey Ltd. Sole importer into the UK of Sealey Quality Machinery.
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
fig.9
We, the sole importer into the UK, declare that the product listed here is
01284 757500
01284 703534
fig.6
fig.10
fig.13
18th September 2007
www.sealey.co.uk
Web
sales@sealey.co.uk
email
Advertisement
