Table of Contents
Advertisement
❏ Final Installation
Lead Connections
Connect all wires, making sure that each connection
is insulated and secure. Bundle all loose wires and
fasten them with tape so they won't fall down later.
Congratulations! After making a few final checks,
you're ready to enjoy your new auto stereo system.
❏ Precautions
We strongly recommend that you wear gloves for installation work to protect yourself from injuries.
¡Disconnect the cable from the negative (–) battery
terminal (see caution below).
¡Unit should be installed in a horizontal position
with the front end up at a convenient angle, but
not more than 30°.
Caution : Do not disconnect the battery terminals of a car with trip or navigational computer since all user
settings stored in memory will be lost. Instead take extra care with installing the unit to prevent shorts.
This unit should be professionally installed. In case of difficulty, please consult with your nearest professional installer.
1. This unit only operates in a 12-volt DC negative ground system.
2. Follow the electrical connections carefully
3. Connect the power lead after all other connections are made.
4. Be sure to connect the battery lead (yellow) to the positive terminal (+) of the battery or fuse block (BAT) terminal.
5. Insulate all exposed wires to prevent short circuiting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation instructions of the respective equipment before connecting it to this
unit.
Caution : Please follow the laws and regulations of your state, province or country for installation of the
unit.
❏ Final Checks
1. Make sure that all wires are properly connect-
ed and insulated.
2. Turn on the ignition to check the unit for prop-
er operation.
If you have difficulties, consult your nearest autho-
rized professional installer for assistance.
(a
Page 48 to 52). Failure to do so may result in damage to the unit.
less than 30°
CA-TU7000U
E
N
G
L
I
S
H
36
45
Advertisement
Table of Contents
