Advertisement
Remove Electrical Connections
Remove 4 x #2 Philips screws to remove vent assembly
from OEM radio
Remove OEM radio bracket/Re-Install to
Rosen System
Remove 4 x 8mm screws per side to remove OEM radio
bracket and re-install OEM Brackets to the Rosen system
using 4 x 8mm screws. 3
Rosen) will need to be installed on Rosen Unit
LOCATING REMOTE COMPONENTS
You will need to mount the GPS and Optional Satellite Radio Antennas on the exterior of the
vehicle. And mount the iPod Interface Connector in the vehicle. The following steps will help guide
Use Caution around SRS Components
It is the installer's responsibility to ensure that the safety
equipment in the vehicle is NOT adversely affected by
installation of this system. Ensure that the routing of the
harnesses do NOT obstruct airbags, SRS or other safety
Mount the GPS and Sat Radio antenna in a
location on the exterior of the Vehicle
Route the GPS harness away from other power harnesses in the
This will help to ensure optimum performance of the GPS
Install the iPod interface connector in a
location accessible to the end-user
Locate the iPod interface module in an area which can be
serviced in the future.
The iPod cable is intended to be a serviceable item, which plugs
into the iPod/Sat radio Interface Module.
Rosen Entertainment Systems
Installation Guide
Installation Guide Universal Series
rd
party dash kit(not supplied by
you through this process.
devices.
vehicle.
system.
CAUTION
CAUTION
STEP
3
Copyright 2010 All Rights Reserved
DP-UN1014 Rev B
Page 4
Advertisement
