Advertisement
INSTALL THE ROSEN NAVIGATION SYSTEM
You will need to prepare the Rosen Navigation System for installation in the vehicle.
Remove the DVD Transport Screws
There are 2 x Phillips Transport Screws which protect the DVD
Mechanism during transportation.
Transport Screws must be removed prior to installation.
Connect the Power and GPS Harnesses
The GPS Harness must be tightened with a WRENCH to ensure
it is properly seated.
Failure to follow this step may result in poor GPS signal
Connect Optional Harnesses such as iPod,
Satellite Radio, Camera, Reverse Sensors
These harnesses must be fully engaged prior to the system
See the Harness Diagrams for more information
Prepare the Vehicle side harnesses for
connection to the Rosen Harness
Use care not to pinch or damage cables as this will cause
performance issues/failures
Mount Rosen Navigation into Dash
Insert Rosen Navigation System into dash and mount
using OEM 6 x 7mm bolts
Be sure to engage all connectors
Rosen Entertainment Systems
Installation Guide
Installation Guide Universal Series
installation.
STEP
4
CAUTION
Copyright 2010 All Rights Reserved
DP-UN1014 Rev B
Page 5
Advertisement
