Power Outlets; Uconnect™ Phone - Dodge 2010 Grand Caravan User Manual

2010 grand caravan
Hide thumbs Also See for 2010 Grand Caravan:
Table of Contents

Advertisement

ELECTRONICS

POWER OUTLETS

• There are four 12-volt power outlets in your vehicle. Two are located on the lower
instrument panel, next to the open storage bin. The upper power outlet is controlled
by the ignition switch and the lower power outlet is connected directly to the battery.
One is located in the removable floor console and is also connected directly to the
battery. One is located in the rear quarter panel near the liftgate. This outlet is also
controlled by the ignition switch.
NOTE: Do not exceed the maximum power of 160 Watts (13 Amps) at 12 Volts. If the 160
Watt (13 Amp) power rating is exceeded the fuse protecting the system will need to be
replaced.
uconnect™ phone
• The uconnect™ phone is a voice-activated, hands-free, in-vehicle communications
system.
• The uconnect™ phone allows you to dial a phone number with your cellular phone
using simple voice commands.
• Please refer to uconnect™ phone in the uconnect™ User's Manual on the DVD for
further details.
• Any voice commanded system should be used only in safe driving conditions
following local laws and phone use. All attention should be kept on the roadway
ahead. Failure to do so may result in an accident causing serious injury or death.
• Your phone must be turned on and paired to the uconnect™ phone to allow use of
this vehicle feature in emergency situations, when the cellular phone has network
coverage and stays paired to the uconnect™ phone.
NOTE: The uconnect™ phone requires a cellular phone equipped with the Bluetooth
Hands-Free Profile, Version 0.96 or higher. For uconnect™ customer support, call
1–877–855–8400.
Phone Pairing
NOTE: Pairing is a one-time initial setup before using the phone. You will also need to
follow the Bluetooth instructions in your cell phone user guide to complete the phone
pairing setup.
• Press the Phone button
• Wait for the "ready" prompt and beep.
• (After the BEEP), say "uconnect setup".
• (After the BEEP), say "phone pairing".
• (After the BEEP) say, "pair a phone".
• Follow the audible prompts.
WARNING!
to begin.
42
®

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents