Universal Garage Door Opener - Dodge 2010 Grand Caravan User Manual

ELECTRONICS

UNIVERSAL GARAGE DOOR OPENER

• Place the hand-held transmitter 1 to 3 in (3 to 8 cm) from the HomeLink
while keeping the indicator light in view.
• Simultaneously, press and hold both the chosen HomeLink
hand-held transmitter button until the HomeLink
slow to a rapidly blinking light, then release both the HomeLink
transmitter buttons. This may take up to 30 seconds, or longer, in rare cases.
• Press and hold the just-trained HomeLink
constantly, programming is complete and the garage door should open.
• Your motorized door or gate will open and close while you are training the universal
transceiver. Do not train the transceiver if people or pets are in the path of the door
or gate. Only use this transceiver with a garage door opener that has a "stop and
reverse" feature as required by Federal safety standards. This includes most garage
door opener models manufactured after 1982. Do not use a garage door opener
without these safety features. Call toll-free 1–800–355–3515 or, on the Internet, at
www.HomeLink.com for safety information or assistance.
• Vehicle exhaust contains carbon monoxide, a dangerous gas. Do not run your
vehicle in the garage while training the transceiver. Exhaust gas can cause serious
injury or death.
NOTE: If you are having difficulty training your HomeLink
was manufactured after 1995, you may have a rolling code. Follow the steps for
Programming A Rolling Code System.
Programming A Rolling Code System
• At the garage door opener motor (in the garage), locate the "learn" or "training"
button. This can usually be found where the hanging antenna wire is attached to the
garage door opener motor (it is NOT the button normally used to open and close the
door).
Programming HomeLink
Begin Programming
• The HomeLink
sun visor.
• Erase all channels before you begin training
by holding the two outside buttons for up to
20 seconds until the red indicator flashes.
• Park your vehicle outside of the garage and
turn the ignition switch to the ON/RUN
position.
®
indicator flash rate changes from a
®
button; if the indicator light stays on
WARNING!
40
®
®
buttons are located in the
®
buttons
®
button and the
®
and the hand held
®
and your garage door opener