Table of Contents
Advertisement
SMART ROLLER
WARNING: IT IS VITAL FOR THE SAFETY OF ALL
PERSONS INSTALLING AND USING THIS OPENER TO
FOLLOW THE INSTALLATION INSTRUCTIONS AND
SAFETY WARNINGS. FAILURE TO COMPLY MAY RESULT
IN SERIOUS PERSONAL INJURY AND/OR PROPERTY
DAMAGE AND FAILURE OF THE OPENER SYSTEM.
smart
o p eners
ROLL UP DOOR OPENER
duo
DU
INSTALLATION
MANUAL
Advertisement
Table of Contents
Related Manuals for Smart Openers SMART ROLLER DUO
Summary of Contents for Smart Openers SMART ROLLER DUO
- Page 1 smart o p eners SMART ROLLER ROLL UP DOOR OPENER INSTALLATION WARNING: IT IS VITAL FOR THE SAFETY OF ALL PERSONS INSTALLING AND USING THIS OPENER TO FOLLOW THE INSTALLATION INSTRUCTIONS AND MANUAL SAFETY WARNINGS. FAILURE TO COMPLY MAY RESULT IN SERIOUS PERSONAL INJURY AND/OR PROPERTY DAMAGE AND FAILURE OF THE OPENER SYSTEM.
-
Page 2: Table Of Contents
INFORMATION FOR THE USER WARRANTY To the extent that they may be lawfully excluded, Smart Openers Pty Ltd hereby expressly excludes all conditions and warranties, statutory or otherwise, which may be implied by law as conditions or warranties of purchase of a Smart Openers Pty Ltd Garage Door Opener. Smart Openers Pty Ltd hereby further... -
Page 3: Contents
It is the responsibility of the installer to adhere Safety Issues associated with the installation and use of to all relevant safety standards. a Smart Roller Duo roll up door opener refer to the safety warnings in the OWNERS MANUAL. The Smart Roller Duo opener is designed and... -
Page 4: Operating Controls
Operating Controls +24V PE DIP 11 12 10 9 Prog Lrn Run 19 20 16 17 18... - Page 5 Operating Controls 1 +24V, PB, GND - used for connecting 2 or 3 wire 10 24 Volt Battery Input Photo Electric beam. 11 Learn Button - used to store transmitter into memory. 2 PE Dipswitch setting - set dipswitch down when 12 Learn LED - indicates learn/operate mode of connecting Photo Electric Beams.
-
Page 6: Before Installation
5) A 240V, adequately protected 3-pin socket must be the risks relating to automating the door. Verify that near where the Smart Roller Duo opener is going to the door to be automated is in a sound condition be installed. -
Page 7: Side Room Requirements
Refer to the door manufacturer’s instructions for proper adjustment procedure. Left or Right Hand Installation The Smart Roller Duo is shipped from the factory ready for installation on the RIGHT SIDE of the door (when WEIGHT BAR viewed from inside the garage). -
Page 8: Mounting Drive Unit
Installation Fitting Drive Unit to Door (1 ) Check if U bolt is tightened Note: The following instructions are for RIGHT HAND (4 ) Remove right U bolt SIDE installation (from the inside looking out). 1 Check that the U-Bolt on the opposite end of the door shaft is securely tightened. -
Page 9: Limits Set Up - Right Hand
Limits Set Up REMINDER: If you have not already done so, inspect the wiring harness to confirm that the motor wires are connected correctly: red–red and green–yellow. Also check that the L/H-R/H dipswitch has been set correctly. Setting Limits - RIGHT HAND INSTALLATION 1 With the Drive Unit in manual mode move the door up by hand to the desired open position. -
Page 10: Limits Set Up - Left Hand
Limits Set Up Setting Limits - LEFT HAND INSTALLATION Adjust cam clockwise Note: The RH/LH dip switch must be set to LH side. to open the door more REMINDER: If you have not already done so, inspect the wiring harness to confirm that the motor wires are connected correctly: red–red and green–yellow. -
Page 11: Obstruction Force Margin
Obstruction Force Margins Setting Safety Obstruction Force Margins IMPORTANT: The setting for the close obstruction force margin is the most important adjustment in the installation Prog Lrn Run procedure. Make sure that the force (load) is adjusted correctly as per the installation instructions. Failure to Down force adjust these settings correctly could result in serious adjustment... -
Page 12: Coding Transmitter
LED Array transmitters. DELETING ALL TRANSMITTERS 1 Press and hold the LEARN BUTTON, the LEARN NOTE: Smart Openers Pty Ltd reserves the right to LED will turn on. modify its product and product specifications at any time without prior notice. -
Page 13: Final Notes
It is important for the installer to show their clients correct Do not let children play near the door and keep the operational use of the Smart Roller Duo including the use remote controls out of their reach. of the manual disengagement cord. -
Page 14: Warranty
6. To the extent permissible by statute, Smart Openers disclaims any liability of whatsoever nature in respect of any claim or demand for loss or damage which arises out of: accidental or deliberate damage to, or normal wear and tear to, the product or to the product’s components;... - Page 15 Notes -15-...
- Page 16 Email: enquiries@smartopeners.com Web: www.smartopeners.com © November 2007 Smart Openers Pty Ltd. All rights reserved. In an ongoing commitment to product quality and innovation smart openers reserves the right to change and alter specifications and model numbers and types without notice...
Need help?
Do you have a question about the SMART ROLLER DUO and is the answer not in the manual?
Questions and answers
how to replace the light Bulb