Hoveround MPV5 Owner's Manual page 17

Hoveround-MPV5ManualRevM
1. With the power turned OFF, hold the joystick and move it to
determine the limits of movement. Observe that, when
released, the joystick returns to center (neutral).
2. Allow plenty of space to test drive your power wheelchair.
3. With the joystick in the center position (neutral), turn chair
power on. Check battery gauge for adequate
battery capacity.
4. Set the Speed/Response Control to the lowest level.
To avoid serious injury or death from a fall or collision, set speed/
response control for the environment and your skill level. Set
control to minimum if you are a less experienced driver or are
in a confined space.
5. Gently move the joystick forward. A "click" will be heard as
the controller releases the motor brakes and your power
wheelchair will move slowly forward. Observe that if the joystick
is released, the lever will return to center (neutral) and the
power wheelchair will stop. Note that when the chair stops,
another "click" will be heard as the brakes are engaged.
6. Move the joystick lever fully right. The chair will move in a circle
to the right. Moving the lever fully left will cause the chair to
circle to the left.
D82008753M 10/13
1/17/14 10:36 AM Page 17
If the status indicator is flashing, the controller has
sensed a fault condition. Refer to the fault code
section of Appendix B (pages 50 - 51) to determine
the cause of the fault. The power wheelchair will not
respond to move commands if a fault condition is
sensed.
Chapter 1 17