Panasonic KX-TDE600 Programming Manual page 14

2.1.1 Installing and Starting the Maintenance Console
When using a DHCP server:
a.
Select Enable for the DHCP Client setting.
b.
Click Apply.
Note
The boxes will turn grey and the IP addresses will be assigned automatically after the PBX is reset.
When not using a DHCP server:
a.
Select Disable for the DHCP Client setting.
b.
In the IP Address for IPCEMPR Card box, type the IP address of the IPCEMPR card.
c.
In the IP Address for VoIP-DSP box, type the IP address of the DSP16 or DSP64 card.
d.
In the Subnet Mask box, type the subnet mask address of the network.
e.
In the Default Gateway box, type the IP address of the default gateway.
f.
Click Apply.
When using a DHCP server to obtain a DNS server IP address automatically:
a.
Select DHCP for the DNS Server Address Method setting.
b.
Click Apply.
Note
The boxes will turn grey and the IP addresses will be assigned automatically after the PBX is reset.
When not using a DHCP server to obtain a DNS server IP address automatically:
a.
Select Manual for the DNS Server Address Method setting.
b.
In the Manual Preferred DNS Server IP Address box, type the IP address of the preferred DNS
server.
c.
In the Manual Alternate DNS Server IP Address box, type the IP address of the alternate DNS
server.
d.
Click Apply.
The system menu appears. You may now begin programming the PBX.
Notice
•
Do not change the IP addresses of the IPCEMPR and DSP cards once IP telephones are
registered to the PBX using these IP addresses.
The IP telephones will not operate properly if these IP addresses are changed.
•
A DHCP server must be able to use a "client identifier" option specified by RFC 2131.
•
The PBX will not start properly if the IP addresses cannot be assigned automatically by the
DHCP server when DHCP Client is set to Enable. In this case, you need to consult your
network administrator because the DHCP server on your network may not be running or a
network failure may have occurred. If the DHCP server cannot be available, change the DHCP
Client setting to Disable and set fixed IP addresses, then restart the PBX.
To change the DHCP Client setting, connect the PC with an RS-232C cross cable or Ethernet
straight cable. When connecting the PC with an Ethernet straight cable, make sure the PBX
is disconnected from the LAN and then connect the PC with an Ethernet straight cable using
192.168.0.101 for the IP address of the IPCEMPR card.
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*1
*2 Valid IP address range: "1.0.0.0" to "223.255.255.255"
*3 Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except 0.0.0.0 and 255.255.255.255)
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*4
14 Programming Manual for Virtual SIP CO Line Card
*1
*2
*3
*4
Document Version 2008-11