Table of Contents
Advertisement
Integrating with Cisco Unified
Communications Manager 6.0/7.x
This chapter describes a sample configuration of Cisco Unified Communications
Manager 6.0 for integration with the EasyCall Gateway through a SIP trunk. The
examples show the Cisco Unified Communications Manager (previously referred to as
CallManager) administration software screens.
Note
The following topics describe the integration:
"Configuring the SIP Trunk Security Profile" on page 27
"Configuring the SIP Trunk" on page 28
"Configuring the SIP Profile" on page 31
"Configuring Call Forwarding" on page 33
"Verifying the Integration" on page 37
Configuring the SIP Trunk Security Profile
The following screen shows a sample SIP trunk security profile configuration. The
table after the screen describes the values that are important for EasyCall Gateway
integration.
Configuration for Cisco Unified Communications Manager 7.0 is similar to
version 6.0. You can follow the instructions in this chapter and leave any
parameters that are new to 7.0 set to their defaults.
C
5
HAPTER
Advertisement
Table of Contents
Need help?
Do you have a question about the EasyCall Gateway 3.0 and is the answer not in the manual?
Questions and answers