General Precautions - Toshiba e-STUDIO 2500c Operator's Manual

General Precautions

When installing or moving
Warning
This Multifunctional Digital Colour Systems requires 220 to 240 V AC, 8 A 50/60 Hz electric
power.
Do not use a power supply with a voltage other than that specified.
Avoid multiple connections in the same outlet. This could cause a fire or give you an electric
shock. If you are considering increasing the number of outlets, contact an electrician.
Always connect this Multifunctional Digital Colour Systems to an outlet with an earth connec-
tion to avoid the danger of fire or electric shock in case of short-circuiting. Contact your ser-
vice representative for the details. Be sure to use a 3-conductor, grounded wall outlet.
In areas, except U.S. and Canada, where a 2-pin plug is used, the Multifunctional Digital
Colour Systems must be grounded for safety. Never ground it to a gas pipe, a water pipe, or
any other object not suitable for grounding.
Plug the power cord securely into the outlet. If it is not plugged in properly, it could heat up
and cause a fire or give you an electric shock.
Do not damage, break or attempt to repair the power cord.
The following things should not be done to the power cord.
- Twisting it
- Bending it
- Pulling it
- Placing anything on it
- Making it hot
- Situating it near radiators or other heat sources
This could cause a fire or give you an electric shock. If the power cord is damaged, contact
your service representative.
Do not install the equipment by yourself or try to move it once it has been installed. This
could result in an injury or damage to the device. Contact your service representative if the
equipment needs to be installed or moved.
The socket outlet shall be near the equipment and be easily accessible.
Pull out the plug from the outlet more than once a year to clean around the prongs. Accumu-
lating dust and dirt could cause a fire due to the heat released by electric leakage.
General Precautions 21