Table of Contents
Advertisement
OBJECT HANDLING --- IF EQUIPPED
WARNING: When using machine for object handling
operation, be sure to comply with EN 474-5, which
prescribes that the machine must be equipped with
the rated lifting-load table, lifting hook, overload
alarm device, and hoserupture safety valve when ap-
plied to object handling.
Lifting hook, cables, straps, or ropes can break, caus-
ing serious injury. Do not use damaged chains, lifting
hook, frayed cables, slings, straps, or ropes to crane.
Never move the load suddenly. Never move load over
a person's head. Do not allow any persons near load.
Keep all persons away from raised load until blocks
are supporting it or load is sitting on the ground.
Position upperstructure so that the travel motors are
at the rear.
Do not attach sling/chain to the bucket teeth.
Be sure that the maximum lifting load does not ex-
ceed the rated load as shown in the lifting load table
plate or operator's manual.
The overload alarm device warns the operator with a
buzzer sound when the lifting load exceeds the lifting
capacity. If the buzzer sounds, immediately move the
load into the safety range, or lower the load on the
ground.
Be sure to turn the overload alarm device switch ON
while the machine is used for object handling.
When the machine specifications are modified from
the original specifications of the machine delivered,
for example, changing the front attachment or track
shoes, changing or new installing the overload alarm
device may be require. Be sure to consult your autho-
rized Hitachi dealer.
Check that the specifications of the front and machine
to be used meet the specifications shown on the rated
lifting load table. If any discrepancies between them
are found, replace the rated lifting load table so that
no discrepancy is found.
OPERATING THE MACHINE
5-35
Rated lifting load table
T1V1-05-02-004
SA-014
M1U1-05-004
M1U1-01-010
Advertisement
Table of Contents
