How To Cancel The Auto Restart Function; Power Failure During Timer Operation - Toshiba RAS-18N3KVR-E Service Manual

9-3-2. How to Cancel the Auto Restart Function

To cancel auto restart function, proceed as follows :
Repeat the setting procedure : the unit receives the signal and beeps three times.
The unit will be required to be turned on with the remote controller after the main power supply is turned off.
• When the system is on stand-by (not operating)
Operation
Push [RESET] button for more than
three seconds. (Less than 10 seconds)
PRE.DEF
• When the system is operating
Operation
Push [RESET] button for more than
three seconds. (Less than 10 seconds)
PRE.DEF

9-3-3. Power Failure during Timer Operation

When the unit is turned off because of power failure during timer operation, the timer operation is cancelled.
In that case, set the timer operation again.
NOTE :
The Daily Timer is reset while a command signal can be received from the remote controller even if it
stopped due to a power failure.
The unit is on standby.
↓
The unit starts to operate.
↓
After approx. three seconds,
The unit beeps three times and continues to operate.
If the unit is not required to operate at this time, push [RESET]
button once more or use the remote controller to turn it off.
The unit is in operation.
↓
The unit stops operating.
↓
After approx. three seconds,
The unit beeps three times.
If the unit is required to operate at this time, push [RESET] button
once more or use the remote controller to turn it on.
– –
43
FILE NO. SVM-12070
Motions
The green indicator is on.
Motions
The green indicator is on.
The green indicator is turned off.