Table of Contents
Advertisement
17
Excessive towed loads can cause loss of traction and loss of
control on slopes. Reduce towed weight when operating on
slopes. The surface being driven on greatly impacts traction and
stability. Wet or slippery surfaces can greatly reduce traction
and the ability to stop or turn. Carefully evaluate the surface
conditions before operating the unit and trailer, and never operate
on slopes greater than 10°. See SLOPE OPERATION and
TOWED EQUIPMENT in the safety section of this manual for
additional safety information.
Check Engine Oil Level
Interval: Before Each Use
Refer to the engine owners manual for dipstick and oil fill
locations and specific engine oil check and fill procedures.
Check Hydraulic Oil Level
Interval: Before Each Use
1. Before removing the reservoir cap, make sure the area
around the reservoir cap and fill neck of the reservoir is free
of dust, dirt, or other debris.
2. Unscrew the reservoir cap (A, Figure 18).
18
3. Look down the filler neck of the hydraulic oil reservoir (B)
and observe the oil level. When cold, the oil level should be
approximately 4" (10 cm) below top of the filler neck.
4. If necessary, add either Mobil 1™, 15W-50 synthetic oil or
Castrol Syntec™ 5W-50 oil. DO NOT use conventional oils.
5. Reinstall the reservoir cap.
Checking Tire Pressures
Tire pressure should be checked periodically, and maintained
at the levels shown in the Specifications chart. Note that these
pressures may differ slightly from the "Max Inflation" stamped
on the side-wall of the tires. The pressures shown provide proper
traction and extend tire life.
Lubrication
Lubricate the unit at the locations shown in Figures 19, 20 and
21 as well as the following lubrication points.
Grease
Use grease fittings when present. Disassemble parts to apply
grease to moving parts when grease fittings are not installed.
front caster wheel axles & yokes
deck lift pivot blocks
mower deck spindles
mower deck idler arm
21
Hide quick links:
Advertisement
Table of Contents
