Connect The Cable To The Indoor Unit; Piping And Drainage - Panasonic CS-E15DTEW Service Manual

11.2.5. CONNECT THE CABLE TO THE INDOOR UNIT

Open the control box at the bottom end of the chassis and
connect the cable through the hole.
• Connect the wires to the terminals on the control board
individually according to the outdoor unit connection.
• Ensure the color of wires of outdoor unit and the
terminal Nos are the same to the indoor's respectively.
• Secure the cable onto the control board with the holder
(clamper).
• Insert two tabs on the Side panel into two slots on the
chassis, and secure it to the chassis with the screw.

11.2.6. PIPING AND DRAINAGE

Piping and Drainage
• Cut off the Chassis with a nipper according to the inner surface for the Pipings.
• Align the center of the pipings and sufficiently tighten the flare nut with fingers.
• Finally tighten the flare nut with torque wrench, ensure the direction for tightening follows the arrow on the wrench.
• Wrap the tube joining areas with insulating material so that there are no gaps (if it overlaps, cut the excess material) refer
diagram in "Pipe formings, insulating and finishing".
• Connect the drain hose (insulated) to the drain outlet.
CS-E15DTEW CU-E15DBE / CS-E18DTEW CU-E18DBE / CS-E21DTES CU-E21DBE
57