Table of Contents
Advertisement
General Adjustment
Item
V S Linearity
Horizontal Size
Horizontal
Position
Pincushion
Side Pin W
Side Pin S
Screen Image
- 13 -
Adjustmant Procedure
1) Receive NTSC RETMA signal.
2) The Screen mode should be selected on 16:9
mode.
3) When the center area of RETMA signal's circle is
S type in the vertical direction, adjust VS
Linearity so that vertical interval may be the
same.
1) Receive NTSC RETMA signal.
2) The Screen mode should be selected on 16:9
mode
Adjust Horizontal Size for over scanning rate
106%. Check if the center circle of RETMA signal
is circle on Normal mode.
1) Receive NTSC RETMA signal.
2) The Screen mode should be selected on 16:9 mode
3) Adjust Horizontal Position so that the circle of
RETMA signal may be centered in the horizontal
direction.
1) Receive NTSC Cross Hatch signal.
2) The Screen mode should be selected on 16:9
mode.
3) When the vertical lines of the left and right side
are distorted such as the left figure, adjust
Pincushion so that the vertical lines may be
straight.
1) Receive NTSC Cross Hatch signal.
2) The Screen mode should be selected on 16:9
mode.
3) When the vertical lines of the left and right side
are not straight but distorted in the W type, adjust
Side Pin W to correct the unbalanced vertical
lines.
1) Receive NTSC Cross Hatch signal.
2) The Screen mode should be selected on 16:9
mode.
3) When vertical lines of the left and right side is not
straight but distorted in the S type, adjust Side Pin
S to correct the unbalanced vertical lines.
Advertisement
Table of Contents
