Sanyo VPC-CG20 Service Manual page 17

3-6. The adjustment item which in necessary in part exchange
COMPL PWB CP1
COMPL PWB VF1
COMPL PWB ST1
COMPL PWB TB1
COMPL PWB TB2
ASSY, FLEXIBLE PWB CA1
LENS
: Be sure to carry out the necessary adjustments after replacing the unit.
: Adjustment is possible from the menu setting screen of the camera and by using the calibration software.
3-7. Updating the firmware
Check the firmware version immediately after the CP1 board has been replaced. If an old version is being used, interfer-
ence and errors in operation may also occur. If an old version is being used, update it with a newer version.
3-13. Firmware uploading procedure. (Page 21)
Refer to
3-8. Adjust Specifications
1. Lens Adjustment (Infinity)
Camera
Preparation:
POWER switch: ON
If using a ready-made collimator, set to infinity.
Lens
Lens
Adjust-
Adjust-
Adjust-
ment ment
(Infinity) (1 m)
Collimator
CMOS Black
CMOS
Point And
AWB
White Point
White Point
Defect
Defect Detect
Detect
ment
Adjustment
Adjustment
In Lighted
Note:
Do not vibrate during the adjustment.
If readjusting after it has already been adjusted, wait for 15
minutes or more for the unit to cool down first.
Adjustment method:
1. Set the camera so that it becomes center of the siemens
star chart in the collimator (zoom wide and tele).
(Set a distance of 0.5-1.0 cm between camera lens and
collimator lens. Do not touch the each lens.)
2. Double-click on the DscCalDi.exe.
3. Select "Infinity Cal." on the LCD "Test", and click the "Yes".
4. Lens infinity adjustment value will appear on the screen.
5. Click the OK.
2. Lens Adjustment (1m) is carried out after this adjust-
ment.
– 17 –
USB
Factory
Language
storage
Cord
Setting
information
Setting
registration
Reset
Setting