Table of Contents
Advertisement
DO NOT use a PTO adapter to attach a non-matching Implement driveline to a Tractor
PTO. Use of an adapter can double the operating speed of the Implement resulting in
excessive vibration, thrown objects, and blade and implement failure. Adapter use will also
change the working length of the driveline exposing unshielded driveline areas. Serious
bodily injury and/or equipment failure can result from using a PTO adapter. Consult an
authorized dealer for assistance if the Implement driveline does not match the Tractor PTO.
(S3PT-14)
Never operate the Tractor and Mower if the Implement input driveline is directly connected
to the Tractor transmission. Tractor braking distances can be substantially increased by
the momentum of the rotating Mower blades driving the Tractor transmission even though
the Tractor clutch has been disengaged. Install an over running clutch between the Tractor
PTO and the Mower driveline to prevent this potentially dangerous situation.
Do not connect the PTO driveline to the tractor or operate the implement unless the
implement is securely connected to the tractor.
2.8 Tire Spacing
Tractor tires should be set a minimum of 60"(1.5
mm) apart measured from inside of tire to inside of
tire.
Refer to the tractor Operator's Manual or
consult an authorized dealer for instructions to
change tractor tire spacing. OPS-R- 0062
3. GETTING ON AND OFF THE TRACTOR
Before getting onto the tractor, the operator must read and completely understand the implement and tractor
operator manuals. If any part of either manual is not completely understood, consult an authorized dealer for
a complete explanation. OPS-U- 0007
Do not mount or dismount the Tractor while the tractor is moving. Mount
the Tractor only when the Tractor and all moving parts are completely
stopped.
RX60/72/84 10/12
© 2012 Alamo Group Inc.
OPERATION
(SG-12)
Operation Section 4-7
(S3PT-16)
Advertisement
Table of Contents
