Asus ESC4000 G3 Series User Manual page 168

3. The utility immediately starts rebuilding after the disk is selected. When done, the
status of the degraded RAID volume is changed to "Rebuild".
Intel(R) Rapid Storage Technology enterprise - SATA Option ROM - 3.6.0.1023
RAID Volumes:
ID
1
Physical Devices:
Port
1
2
Volumes with "Rebuild" status will be rebuilt within the operating system.
[
4. Press <Esc> to exit Intel Rapid Storage Technology and reboot the system.
5. Select Start > Programs > Intel Rapid Storage > Intel Rapid Storage Console
or click the Intel Rapid Storage Technology tray icon to load the Intel Rapid Storage
Manager utility.
6. From the View menu, select Advanced Mode to display the details of the Intel Rapid
Storage Console.
7. From the Volumes view option, select RAID volume to view the rebuilding status. When
finished, the status is changed to "Normal".
Rebuilding the RAID with a new hard disk
If any of the SATA hard disk drives included in the RAID array failed, the system displays the
status of the RAID volume as "Degraded" during POST. You may replace the disk drive and
rebuild the RAID array.
To rebuild the RAID with a new hard disk:
1. Remove the failed SATA hard disk and install a new SATA hard disk of the same
specification into the same SATA Port.
Select a destination disk with the same size as the original hard disk.
2. Reboot the system then follow the steps in section Rebuilding the RAID with other
non-RAID disk.
6-32
Copyright(C) 2003-12 Intel Corporation.
1. Create RAID Volume
2. Delete RAID Volume
[ DISK/VOLUME
Name Level1
Volume0 RAID1(Mirror)
Drive Model Serial #
ST3160812AS 9LS0F4HL
ST3160812AS 3LS0JYL8
]-Select
All Rights Reserved.
[ MAIN MENU ]
3. Reset Disks to Non-RAID
4. Exit
INFORMATION]
Strip Size
N/A 149.0GB
Size
149.0GB
149.0GB
[ESC]-Exit [ENTER]-Select Menu
*=Data is Encrypted
Status Bootable
Rebuild Yes
Type/Status(Vol ID)
Member Disk(0)
Member Disk(0)
Chapter 6: RAID configuration