Maytag RFS9B Service page 35

User Options
Follow the instructions below to customize oven
operation. End-of-cycle signal, maximum cooking time
and other options can be changed to meet your cooking
needs. Example: Change setting to single digit pad
operation.
1. Open oven door.
• If door is closed or RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press and hold pad 2 for approximately 5
seconds.
• After 5 seconds, signal sounds.
• Display shows "0P:".
Numbered Pads
1
End of Cycle Beep
2
Speaker Volume
(Not Available on
RCS10)
3
Key Beep
4
Keyboard Enable
Window
5
Add Time during
Heating
6
Reset Door Open
7
Maximum Heating Time
(Not Available on
RCS10)
8
Manual Operation
9
Double Digit Operation
(Not Available on
RCS10, RCS10MP,
and RCS10MPS)
A–10
2
Display Options (Factory Settings in Bold)
3 second continuous beep.
OP:10
OP:11 Continuous beep until door is opened.
OP:12 5 beeps bursts until door is opened.
OP:20 Speaker off, no beep sounds.
OP:21 Sets volume to low.
OP:22 Sets volume to medium.
OP:23 Sets volume to high.
OP:30 No beep when pad is pressed.
Sound beep when pad is pressed.
OP:31
OP:40 15 seconds after oven door is opened, keyboard disabled
OP:41 30 seconds after oven door is opened, keyboard disabled
OP:42 1 minute after oven door is opened, keyboard disabled
OP:43 2 minutes after oven door is opened, keyboard disabled
OP:50 Prevents adding heating time while oven is heating.
Allows heating time to be changed while oven is heating when a
OP:51
memory pad is pressed.
Allows oven to resume heating time countdown after door is
OP:60
opened during cycle.
Cancels heating time count down when door is opened during cycle.
OP:61
Allows 60 minutes of heating time.
OP:70
OP:71 Allows 10 minutes of heating time.
OP:80 Allows use of preprogrammed pads only.
Allows use of manual time entry and preprogrammed pads.
OP:81
OP:90 Allows 10 (0–9) preprogrammed pads.
OP:91 Allows 100 (00–99) preprogrammed pads.
16021520 Rev. 0
3. Press 9 pad.
• See table below for options.
• Displays shows "OP:91".
• "OP" represents optional program
mode, first number represents option
number and second number represents
functions currently selected for option.
4. Press 9 pad repeatedly to change
setting.
5. Press START pad to save changes.
• Repeat steps 3–5 to change additional
options.
• Changes appear after door is closed or STOP/
RESET is pressed.
6. Press STOP/RESET pad or close oven door to exit
programming mode.
START
STOP
RESET
©2002 Maytag Appliances Company
9