Quick Reference Instructions - Maytag RFS9B Service

Programming Instructions for RCS10MP, P1140412M
RCS10MPS, P1324901M

Quick Reference Instructions

Read "Important Safety Information" before using "Quick
Reference Instructions". If there are unanswered
questions, see detailed sections of this manual.
Operating Preprogrammed Pads
1. Open oven door, place food in oven, and close door.
2. Press desired number pad.
3. Oven stops heating and oven signal sounds when
heating timing elapses.
Manual Time Entry
1. Open oven door, place food in oven, and close door.
2. Press TIME ENTRY pad.
3. Press number pads to enter desired cooking time.
4. Press a power level pad if power level less than 100
percent is required.
5. Press START pad.
6. Oven stops heating and oven signal sounds when
heating timing elapses.
Programming Preprogrammed Number Pads
1. Open oven door.
2. Press and hold pad 1 for approximately 15 seconds.
3. Press desired number pad.
4. Press number pads to enter desired cooking time.
5. Press a power level pad if power level less than 100
percent is required.
6. Press START pad to save new heating time and
power level in oven memory.
7. Press RESET pad or close oven door to exit
programming mode.
Programming Multiple Heating Stages
1. Open oven door.
2. Press pad 1 for approximately 15 seconds.
3. Press desired number pad.
4. Press number pads to enter desired cooking time.
5. Press a power level pad if power level less than 100
percent is required.
6. Press TIME ENTRY pad.
7. Press START pad to save new heating time and
power level in oven memory.
8. Press RESET pad or close oven door to exit
programming mode.
A–4
Programming Deactivating Control Panel
1. Open oven door, and close oven door.
2. Press TIME ENTRY pad.
3. Press 1,3,5, and 7 pad in sequence.
4. Press TIME ENTRY pad.
Deactivating Preprogrammed Pad
1. Open oven door.
2. Press and hold pad 1 for approximately 15 seconds.
3. Press desired number pad.
4. Press hidden pad.
5. Press START pad to save in oven memory.
6. Press RESET pad or close oven door to exit
programming mode.
Reactivating Preprogrammed Pad
1. Open oven door.
2. Press and hold pad 1 for approximately 15 seconds.
3. Press desired number pad.
4. Press hidden pad.
5. Program pad according to "Preprogrammed Number
Pads" section step 5-8.
6. Press START pad to save in oven memory.
7. Press RESET pad or close oven door to exit
programming mode.
User Options
1. Open oven door.
2. Press and hold pad 1 for approximately 15 seconds.
3. Press hidden pad.
4. Press START pad to advance to next option. See
table for options.
5. Press number pad (0,1-3) to change option.
6. Press START pad to save changes.
7. Press RESET pad or close oven door to exit
programming mode.
16021520 Rev. 0
©2002 Maytag Appliances Company