Basic Settings; Setting The Speakers Configuration - JVC LVT1007-010A[A] Instructions Manual

Basic Settings

Some of the following settings are required after connecting and positioning your speakers while others will make
operations easier. You can use QUICK SPEAKER SETUP to easily set up your speaker configuration.

Setting the Speakers Configuration

Quick Speaker Setup helps you to easily and quickly register the
speaker size and speaker distance according to your listening room
to create the best possible surround effect.
• You can also register each speaker's information manually.
For details, see page 25.
RX-7032V
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel:
1. Press QUICK SPEAKER SETUP.
"SETUP" and "SPEAKERS?" appear on the display, then the
initial setting for the total number of the connected speakers
(channels) appears.
ANALOG
L R LINEAR PCM
SUBWFR
ANALOG
L R LINEAR PCM
SUBWFR
2. Turn MULTI JOG to select an appropriate
number of the connected speakers (speaker
channel number).
The speaker channel number changes as follows.
• For the details of speaker channel number, see "Speakers
(channels) number and size" on page 24.
ANALOG
L R
SUBWFR
2.0CH " 2.1CH " 3.0CH " 3.1CH " 4.0CH "
4.1CH " 5.0CH " 5.1CH " 6.0CH* " 6.1CH "
7.0CH " 7.1CH " (Back to the beginning)
* "6.0CH" is the initial setting.
AUDIO/VIDEO CONTROL RECEIVER
SPEAKERS 1
VOLUME
SPEAKERS 1
VOLUME
SPEAKERS 1
VOLUME
3. Press in MULTI JOG (PUSH SET).
Remote
NOT
"ROOM SIZE?" appears on the display, then the initial room
size setting appears.
ANALOG
L R
LINEAR PCM
SUBWFR
ANALOG
L R LINEAR PCM
SUBWFR
4. Turn MULTI JOG to select an appropriate room
size to match to your listening room.
The room size changes as follows.
• To select your appropriate room size, see "Room size and
speaker distance" on page 24.
ANALOG
L R LINEAR PCM
SUBWFR
SMALL " MID " LARGE* " (Back to the beginning)
* "LARGE" is the initial setting.
5. Press in MULTI JOG (PUSH SET).
"COMPLETE" appears on the display, then goes back to the
source indication.
• Speaker configuration settings now become active.
ANALOG
L R LINEAR PCM
SUBWFR
Note:
This procedure will not be completed if you stop in the middle of
the setting process.
SPEAKERS 1
VOLUME
SPEAKERS 1
VOLUME
SPEAKERS 1
VOLUME
SPEAKERS 1
VOLUME
23