Table of Contents
Advertisement
7 Surround back speakers quantity—SBACK OUT
Select the number of the surround back speakers connected.
1SPK: Select this to use 1 surround back speaker.
2SPK: Select this to use 2 surround back speakers.
Note:
If you have selected "NONE" for the surround back speakers (see
page 25), this setting is not available.
Setting the Speaker Distance
The distance from your listening point to the speakers is another
important element to obtain the best possible sound of the Surround
and DSP modes. Set the distance from your listening point to the
speakers.
By referring to the speaker distance setting, this unit automatically
sets the delay time of the sound through each speaker so that sounds
through all the speakers can reach you at the same time.
• If you have used Quick Speaker Setup on page 23, this setting is
not required.
7 Measuring unit—DIST UNIT
Select which measuring unit you use.
meter: Select to set the distance in meters.
feet:
Select to set the distance in feet.
7 Speaker distance—FRONT DISTANCE, CNTR
DISTANCE, SURR DISTANCE, SBACK DISTANCE
Set the distance from the listening point within the range of
0.3 m (1 ft) to 9.0 m (30 ft), in 0.3 m (1 ft) intervals.
• When shipped from the factory, distance for each speaker is
set to "3.0 m (10 ft)."
Notes:
• You cannot set the speaker distance for the speakers you have
selected "NONE" (see page 25).
• This setting is not valid for the DVD MULTI playback mode.
26
C
L
LS
LSB
Ex. In the above case, set the speaker distance as follows:
Front speakers:
3.0 m (10 ft)
Center speaker:
3.0 m (10 ft)
Surround speakers:
2.7 m (9 ft)
Surround back speakers:
2.4 m (8 ft)
R
3.3 m
(11 ft)
3.0 m
(10 ft)
2.7 m
(9 ft)
2.4 m
(8 ft)
2.1 m
(7 ft)
RS
RSB
Advertisement
Table of Contents
